Windy-nation VertaMax Power Inverter Manuel d'utilisateur télécharger pdf (Page 7)

VertaMax User Manual

Revision 1.0

6) Connect cables to the power source:

a) Connect the cable from the Negative (Black) Terminal(s) of inverter to the Negative Terminal of the

power source; ensure a secure connection.

b) Connect the cable from the Positive (Red) Terminal(s) of the inverter to the Positive Terminal of the

power source (the battery’s main fuse or the battery selector switch, if you are using one) ; ensure a

secure connection.

WARNING: If you are making a permanent AC connection to the inverter, make sure that the AC wiring is

performed before any DC wiring is done. (DC hook-up may energize internal components and create an

electrical shock hazard).

3 OPERATION

3.1 POWER

The VertaMax features a Soft Start to handle the power surge that is created when some appliances are

turned on. This feature helps protect both the appliance and the inverter from excessive power draws and

surges.

When the power switch is turned on, the VertaMax Soft Start will smoothly bring up the AC power. The Soft

Start circuitry also activates under excessive loads and short circuits, to quickly turn off power to protect the

device and the inverter. Soft Start will attempt to smoothly bring up the AC power, unless it detects an

excessive load.

3.1.1 Power ON

Ensure the VertaMax is properly installed and connected as shown in Section 2 and ensure the DC Power

Source is ON (if switched).

From the AC Output end of the inverter, switch the rocker power switch up to the ON position. The green

power indicator will light and the VertaMax will now deliver AC power to the outlet(s) on the AC Output end of

the inverter.

Plug the AC product(s) you wish to operate into the AC outlet(s) and switch them on, one at a time.

windynation

Page 7 of 16

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

Windy-nation VertaMax Power Inverter Manuel d'utilisateur Page 7